As an intelligent weak current system, cable tray manufacturers play an important role in our daily life. However, it will also present problems in the past, giving us confusion in life. Do you know what problems the cable tray will have?

一、可能呈現的毛病：電纜的各部分都呈現短路表象，這類毛病可能會形成配電柜上的電流繼電器作業，對電纜形成的損壞十分嚴峻;

1、 Possible problems: All parts of the cable present the appearance of short circuit. Such problems may cause current relay operation on the distribution cabinet, which will cause severe damage to the cable;

二、會呈現的毛?。弘娎|內部呈現短路，這類毛病通常是因?yàn)殡娎|質量低質而形成的，外表上不會流露痕跡;

2、 Problems that will appear: Short circuit appears inside the cable, which is usually caused by the low quality of the cable, and no traces will show on the surface;

三、可能會呈現整條電纜被燒斷或許某處電纜被燒斷，使得電纜在毛病處損壞的十分嚴峻;

3、 The whole cable may be burnt out or the cable may be burnt out somewhere, making the cable severely damaged at the fault;

四、可能會呈現的毛病為電纜橋架只有一條短路，毛病處電纜損壞較輕，但還是會有很明顯的痕跡。

4、 The possible problem is that there is only one short circuit in the cable tray, and the cable at the fault is slightly damaged, but there are still obvious traces.

這類毛病可能會呈現的原因在于電流太大或許電纜質量太差而形成的。

This kind of problem may occur because the current is too high or the cable quality is too poor.

所有的機械設備使用后都要定期進行檢查、保養，電纜橋架廠家就來談?wù)勅绾螌?duì)電纜設備進行檢修、保養：

All mechanical equipment shall be inspected and maintained regularly after use. The cable bridge manufacturer will talk about how to repair and maintain the cable equipment:

1、電纜橋架設備平衡氣缸動作狀況及其機油潤滑系統油路,接頭等測試檢查.

1. Test and check the action of the balance cylinder of the cable tray equipment and the oil circuit and connector of the oil lubrication system

2、電纜橋架設備滑塊與導軌之間的摩擦較為頻繁，應做必要的調整較正，檢查接頭部位的潤滑管路等，保證良好的運轉。

2. The friction between the sliding block and the guide rail of the cable tray equipment is frequent, so necessary adjustment and alignment shall be made, and the lubricating pipeline at the joint shall be checked to ensure good operation.

3、定期為電纜橋架設備齒輪部位潤滑：齒輪傳動箱及內部機件因?yàn)榻?jīng)常運轉損壞的可能性比較大，出現松動的可能性更大。

3. Regularly lubricate the gear parts of the cable tray equipment: the gear box and internal parts are more likely to be damaged due to frequent operation, and the possibility of looseness is greater.

以上就是為大家介紹的有關濟南電纜橋架的詳細的介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以的態度,為您提供服務http://www.weld-1.com

The above is a detailed introduction to Jinan cable tray, and I hope it will be helpful to you. If you have any questions, please contact us. We will provide you with our attitude http://www.weld-1.com